Search
Now showing items 11-20 of 173
Achieving Sustainability, Energy Savings, and Occupant Comfort
(Energy Systems Laboratory (http://esl.tamu.edu), 2009-11)
Sustainability, energy savings, and occupant comfort are not mutually exclusive objectives, as buildings can be designed that incorporate all of these features. Sustainability is often defined as meeting the needs of the ...
Master Plan and Energy Audits at a Large Texas Medical Campus
(Energy Systems Laboratory (http://esl.tamu.edu), 2009-11)
Energy Engineering Associates, Inc. was engaged by the Facilities Resource Management Department at a large medical center in Houston, TX to assist with the development of an Energy Management Master Plan and subsequent ...
Case Studies in Using Whole Building Interval Data to Determine Annualized Electrical Savings
(Energy Systems Laboratory (http://esl.tamu.edu), 2009-11)
Whole building interval analysis to determine savings from energy reduction measures is addressed in several guidelines. The whole building method has typically focused on measured savings where baseline regression models ...
Energy Efficiency/Renewable Energy Impact in the Texas Emissions Reduction Plan (TERP), Volume II--Technical Report, Annual Report to the Texas Commission on Environmental Quality January 2008-December 2008
(2009-12)
The Energy Systems Laboratory, at the Texas Engineering Experiment Station of the Texas A&M University System, in fulfillment of its responsibilities under Texas Health and Safety Code Ann. 388.003 (e), Vernon Supp. 2002, ...
Final Report on Retrospective Testing and Application of an Automated Building Commissioning Analysis Tool (ABCAT)
(2009-12)
More than $18 billion of energy is wasted annually in the U.S. commercial building sector. Commissioning services have proven successful in reducing building energy consumption, but the optimal energy performance obtained ...
Energy Efficiency/Renewable Energy Impact in the Texas Emissions Reduction Plan (TERP), Volume III--Technical Appendix
(2009-12)
The Energy Systems Laboratory (Laboratory), at the Texas Engineering Experiment Station of the Texas A&M University System, in fulfillment of its responsibilities under Texas Health and Safety Code Ann. § 388.003 (e), ...
Transient Surge Measurements Of A Centrifugal Compressor Station During Emergency Shutdowns.
(Texas A&M University. Turbomachinery Laboratories, 2009)
For every centrifugal compressor installation, the design of the surge control system is vitally important to prevent damage of the compressor internal components, seals, and bearings. While most surge control systems are ...
Design And Experimental Evaluation Of A High-Speed, Directly-Coupled, Multi-Megawatt Permanent-Magnet Machine.
(Texas A&M University. Turbomachinery Laboratories, 2009)
This paper reexamines some of the usual assumptions in deploying synchronous machines in multi-megawatt, high-speed application. The detailed design and experimental evaluation of a prototype high-speed, directly-coupled, ...
Verification Full Load Test Of 900 T/H (1,980,000 LB/H) Large Mechanical Drive Steam Turbine For ASU Up To 200 MW (268,000 HP) Based On Principle Of High Scale Model Similarity.
(Texas A&M University. Turbomachinery Laboratories, 2009)
In 2009, the authors designed a compressor drive steam turbine for air separation units (ASU) application up to 200 MW (268,000 hp), using large 500 mm (19.7 inch) blade rows, which have a low-pressure (LP) flow capacity ...
Centrifugal Compressor Applications - Upstream And Midstream.
(Texas A&M University. Turbomachinery Laboratories, 2009)
Centrifugal compressors are used in a large number of different compression application. This tutorial addresses applications for centrifugal compressors in the upstream and midstream sector, such as LNG compression, ...