NOTE: This item is not available outside the Texas A&M University network. Texas A&M affiliated users who are off campus can access the item through NetID and password authentication or by using TAMU VPN. Non-affiliated individuals should request a copy through their local library's interlibrary loan service.
Design and evaluation of a prototype laboratory emission control device for use in a variable air volume, face velocity reducing system
Abstract
A prototype perforated backplane air baffle for a laboratory safety hood was designed, fabricated and its performance was evaluated experimentally. Relative to the historically poor performance of slot baffle design, the perforated metal created better laminar flow through the hood, and decreased turbulence in the form of vortices, ultimately resulting in better hood containment. New performance monitoring techniques were developed to aid in future testing of improved laboratory fume hood designs. Three methods were employed to evaluate the hood's performance: 1) face velocity testing, 2) tracer gas containment testing, and 3) smoke containment. Face velocity data was analyzed to evaluate turbulence and consistency across the hood face with the use of new statistical methods described in this thesis. It was determined that turbulence decreased and velocity uniformity increased as the average face velocity increased and as the open area of the hood face decreased. Tracer gas levels outside of the hood, in the operator's breathing zone, were kept below detectable levels (0.02 ppm) at all face velocity / sash position settings. In this work, a Hood Protection Factor was developed as a quantitative means to compare hood performance. The Hood Protection Factor is a true ratio of the contaminant concentration inside the hood exhaust duct to that in the operator's breathing zone, as both are measured values. A qualitative assessment of the hood's performance was completed by means of smoke testing. Smoke testing showed that smoke was captured / retained without escaping from the hood at all face velocity / sash position settings. Static pressure measurements were taken at the back panel of the hood. Graphical analysis of this data allowed visualization of the uniformity of suction across the perforated air baffle. The prototype backplane air baffle provided reduced turbulence at the hood face, allowing improved containment efficiency. New performance monitoring techniques and statistical evaluation methods were developed so health and safety professionals may better evaluate and design laboratory fume hoods.
Description
Due to the character of the original source materials and the nature of batch digitization, quality control issues may be present in this document. Please report any quality issues you encounter to digital@library.tamu.edu, referencing the URI of the item.Includes bibliographical references (leaves 51-53).
Issued also on microfiche from Lange Micrographics.
Collections
Citation
Lacey, Steven Edward (2000). Design and evaluation of a prototype laboratory emission control device for use in a variable air volume, face velocity reducing system. Master's thesis, Texas A&M University. Available electronically from https : / /hdl .handle .net /1969 .1 /ETD -TAMU -2000 -THESIS -L28.
Request Open Access
This item and its contents are restricted. If this is your thesis or dissertation, you can make it open-access. This will allow all visitors to view the contents of the thesis.