Browsing State Agencies by Title
Now showing items 3340-3359 of 17199
-
(Texas Agricultural Extension Service, 1958)
-
(Texas Agricultural Extension Service, 1970)
-
(2011-08-08)The research focuses on the critical review and prediction of flash points of high molecular weight compounds used mainly in the specialty chemical area. Thus far this area of high molecular weight specialty chemicals has ...
-
(Texas A&M University. Gas Turbine Laboratories, 1973)In recent years mechanical equipment has seen extensive uprating in the form of higher speeds, pressures, temperatures and power levels. The advance in the equipment has reflected itself in making economically feasible ...
-
Critical Mitigation Element Methodology: An Approach to Achieving Consistent Risk Evaluation Results (Mary Kay O'Connor Process Safety Center; Texas &M University. Libraries, 2015)This paper introduces Critical Mitigation Element (CME) Methodology, an Occidental Oil and Gas Corporation (OOG) probability analysis methodology internally developed for the purpose of achieving consistent results when ...
-
(Energy Systems Laboratory (http://esl.tamu.edu); Texas A&M University (http://www.tamu.edu), 2000)Condensation plane analysis for determining critical planes at which condensation may occur can be performed for building assemblies in any climate. Procedures for doing so in heating climates where buildings dry to the ...
-
(Texas A&M University. Turbomachinery Laboratories, 2000)One of the most difficult diagnostic problems for centrifugal compressors is fatigue failure of an impeller, especially those with covers. The structure of a covered impeller is inherently resistant to alternating forces ...
-
(Turbomachinery Laboratories, Department of Mechanical Engineering, Texas A&M University, 1985)A critical speed and unbalance response analysis of an eight-stage centrifugal pump was performed, considering the variation of stiffness and damping coefficients with speed for both the oil firm bearings and the fluid ...
-
(Texas A&M University. Turbomachinery Laboratories, 1993)Rotordynamics has long been one of the major considerations in the design of variable speed rotating equipment. Bearing support stiffness is a significant factor in the designer's ability to predict critical speeds and ...
-
(Texas A&M University. Turbomachinery Laboratories, 1984)As a result of a continuing demand for increased performance, modern turbomachines are sometimes designed to operate near a critical speed. Machines for petrochemical and natural gas service have been purchased and delivered ...
-
(Texas A & M University. Libraries, 1991)
-
(Mary Kay O'Connor Process Safety Center; Texas &M University. Libraries, 2015)In the process of deflagration-to-detonation transition (DDT) in reactive gases, the flame typ- ically accelerates first to the choked flame condition (known as a Chapman-Jouguet deflagra- tion), where it propagates at the ...
-
(Energy Systems Laboratory (http://esl.tamu.edu); Texas A&M University (http://www.tamu.edu), 2001)The Cromer cycle uses a desiccant wheel operating in conjunction with a typical air conditioning system. Simulations and laboratory prototypes demonstrate that the cycle has the potential for enhanced humidity control with ...
-
(Energy Systems Laboratory (http://esl.tamu.edu); Texas A&M University (http://www.tamu.edu), 2000)The Cromer cycle uses a desiccant to move moisture from the saturated air leaving an air conditioning (AC) cooling coil to the air returning to the AC unit from the conditioned space. This has the thermodynamic effect of ...
-
(Texas Agricultural Extension Service, 1968)
-
(Texas Agricultural Extension Service, 1973)
-
(Texas Agricultural Extension Service, 1976)
-
(Texas Agricultural Extension Service, 1971)
-
(Texas Agricultural Extension Service, 1968)
-
(Texas Agricultural Extension Service, 1974)