Design and Analysis of Axial and Radial Flux Magnetic Gears and Magnetically Geared Machines
Abstract
Over the last two decades, magnetic gears and magnetically geared machines gained interest as a promising technology for use in high torque, low speed applications. Magnetic gears accomplish the same task as mechanical gears, but they do so without mechanical contact between the moving components, instead relying on the modulated interaction between the flux generated by magnets on the rotors. Consequently, magnetic gears offer the potential to combine the compact size and cost effectiveness of mechanically geared systems with the reliability and quieter operation of larger direct drive machines.
This work focuses on the development of analysis and design techniques for axial and radial flux magnetic gears and magnetically geared machines. Prototypes of an axial flux magnetic gear, a new compact axial flux magnetically geared machine topology, and a large scale inner stator radial flux magnetically geared machine were constructed and tested to calibrate and validate the analysis tools and investigate the practical considerations associated with the technology. Despite conservative design practices, the largest of these machines achieved a torque density of 82.8 kN∙m/m^3. Additionally, a MATLAB-based infrastructure was developed for controlling various simulation models and analyzing their results. Specifically, parametric 2D and 3D finite element analysis (FEA) models were employed for most of the studies, including the designs of the magnetically geared machine prototypes. This system was also used to conduct other simulation studies focused on a plethora of critical design trends and multi-faceted characterizations of the technology’s potential.
Spurred on by the long simulation times required for FEA models, the later stages of the study describe the development and evaluation of generalized, parametric 2D and 3D magnetic equivalent circuit (MEC) magnetic gear models. These MEC models proved extremely accurate, matching the torque predictions of corresponding FEA models with an average error of less than 2%. The MEC models also achieved simulation speeds up to 300 times faster than those of corresponding FEA models.
Collectively, this work provides the tools and methodology for the systematic evaluation of radial and axial flux magnetic gears. It also characterizes design trends for both topologies and validates the results with experimental prototypes.
Subject
Axial FluxFerrite
Finite Element Analysis
Magnetically Geared Machines
Magnetic Equivalent Circuit
Magnetic Gears
NdFeB
Optimization
Permanent Magnets
Radial Flux
Torque Density
Citation
Johnson, Matthew Christopher (2017). Design and Analysis of Axial and Radial Flux Magnetic Gears and Magnetically Geared Machines. Doctoral dissertation, Texas A&M University. Available electronically from https : / /hdl .handle .net /1969 .1 /191957.
Related items
Showing items related by title, author, creator and subject.
-
El Amri, Iskander (2018-07-31)We report the implementation of a novel magnetic concertation setup for localized finishing of freeform surfaces based on employing electro-permanent magnet arrays configured using a recently developed magnetic concentration ...
-
Kyriazis, Georgios (Texas A&M University, 1993)The Biomedical Magnetic Resonance Laboratory (BMRL) of the University of Illinois at Urbana-Champaign (UIUC) has ordered from the Texas Accelerator Center (TAC) a superconducting, self-shielded, solenoidal magnet with a ...
-
Polgreen, Evelyn Louise (Texas A&M University, 1993)Shatsky Rise, located in the Northwest Pacific, is covered with a thick cap of pelagic, carbonate-dominated sediments with a secondary aeolian component. Ocean Drilling Program Leg 132 recovered Pleistocene to Maestrictian ...