Design of a cross section reduction extrusion tool for square bars
MetadataShow full item record
The objective of this project is to design a tool for moderate cross section reduction of bars that are deformed within a channel slider tool that is used for equal channel angular extrusion (ECAE). The bars that are deformed via ECAE have an initial square cross section with a nominal value of 1.00 in2 and aspect ratios (length/width) ranging between 4 and 6. A systems engineering design methodology is used to generate a topbottom approach in the development of the tool's design. This includes defining a need statement, which is the "Need for an area reduction extrusion tool to replace the current practices of machining ECAE processed billets". The system functions and requirements are defined next and used to generate three concepts that are compared to select the winning concept for further refinement. Major components of the selected tool are: a container, ram, base plate, punch plate, four die-inserts, four wedges and four flange locks. For materials, such as copper (C10100) and aluminum (Al6061-T6), that can be processed by this tool, the upper bound extrusion pressure, which is derived by limit analysis, is set at 192 ksi. The upper bound extrusion pressure is constrained by the buckling limit of the ram, which is 202 ksi. The maximum wall stress experienced by the container is 113 ksi. For materials with the same cross section and dimensions, fixed end conditions of the Ram support larger bucking loads when compared to other end conditions such as rounded ends or rounded-fixed ends. With the application of the upper bound method, an increase in the extrusion ratio of the tool causes a corresponding rise in the optimal cone angle of the die further translating to a rise in the extrusion pressure.
Onipede, Bolarinwa O. (2005). Design of a cross section reduction extrusion tool for square bars. Master's thesis, Texas A&M University. Texas A&M University. Available electronically from