Search
Now showing items 31-40 of 1003
Suppression of automotive radio frequency interference
(Texas A&M University, 1969)
Not available
An automotive engine model for air-fuel ratio control using cylinder pressure information
(Texas A&M University, 1997)
Increasingly strict emission standards require very accurate and fast air-fuel ratio (AFR) control in combustion engines. This thesis addresses the design methodology currently used for synthesizing a control system for ...
A neural network approach to the automated detection of acoustic annoyance in hard disk drives
(Texas A&M University, 1994)
In order to increase efficiency, computing equipment in the office environment is increasing rapidly. However, the increase in efficiency is not optimized since the added equipment also brings added noise to the environment. ...
Coding analysis of the IS-95A reverse link
(Texas A&M University, 1999)
The IS-95A reverse link CDMA system is analyzed from a channel coding point of view. Analytical performance is derived for the Viterbi decoder to perform hard decision decoding. A dual-max decoding metric is suggested to ...
A system for catheter tracking using magnetic resonance
(Texas A&M University, 2002)
MRI guidance of surgical and diagnostic tools is a topic of active research. This thesis describes a system developed in a collaborative effort between BioTex, the MD Anderson Cancer Center and Texas A&M to monitor the ...
An investigation of receiver probe development for magnetic resonance microscopy
(Texas A&M University, 1995)
Much research in Magnetic Resonance Imaging has been directed toward the development of new hardware systems that can obtain high resolution images, typically on the order of tens of microns, for small field-of-views, ...
A preference-based extension for the scalable consensus-based bandwidth allocation protocol in a multicast video conference environment
(Texas A&M University, 2000)
This thesis develops a protocol extension, the Preference-based Allocation eXtension for Layered Sources (PAXLS), to complement the existing Scalable ConsensUs based Bandwidth Allocation (SCUBA) protocol used in allocation ...
Modeling the probability of excitation and the defective part level as testing progresses
(Texas A&M University, 2000)
The primary purpose of digital circuit manufacture testing is to detect defective parts so that they will not be sold to customers. Predicting the defective part level, which results after a set of test patterns has been ...
Low power RF CMOS phase-shifting dual modulus (16/17) prescaler
(Texas A&M University, 2000)
This report describes the research work I undertook for my M.S. degree requirements. The conventional and phase-shifting architectures are compared. Problems with the phase-shifting architecture are analyzed and a new ...
A pulsed electromagnet controller for prepolarized MRI
(Texas A&M University, 2001)
Magnetic resonance imaging (MRI) is a popular medical imaging modality that provides high resolution images with superior contrast. Conventional MRI systems rely on large magnets to generate the main magnetic field, B₀, ...