Search
Now showing items 91-100 of 433
Comparison of various battery technologies for electric vehicles
(Texas A&M University, 1993)
Battery technologies of different chemistries, manufacture and geometry were evaluated as candidates for use in Electric Vehicles (EV). The candidate batteries that were evaluated include four single cell and seven ...
An experimental and analytical investigation of the operational characteristics of a capillary pumped loop
(Texas A&M University, 1993)
An experimental investigation was conducted on a relatively new and unique type of capillary pumped loop (CPL) at various power inputs and adverse tilts in order to verify the operational parameters and measure the performance ...
Dynamic pressure response of water flow between closely spaced roughened flat plates
(Texas A&M University, 1993)
A flat plate tester was designed and built to determine friction factors and dynamic pressures for water flow over smooth, knurl, and cavity plates. Reynolds numbers between 2000 and 35000 were obtained at plate clearances ...
Investigation of the heat pipe arrays for convective electronic cooling
(Texas A&M University, 1993)
A combined experimental and analytical investigation was conducted to evaluate a heat pipe convective cooling device consisting of sixteen small copper/water heat pipes mounted vertically in a 4x4 array 25.4 mm square. ...
Submersible control using the Linear Quadratic Gaussian with Loop Transfer Recovery (LQG/LTR) method
(Texas A&M University, 1993)
Not available
Laser velocimetry study of the flow field in a centrifugal pump
(Texas A&M University, 1993)
The flow field in the impeller passages in a centrifugal pump was measured using a two dimensional laser 2-focus velocimeter. Measurements were taken at three circumferential (azimuthal) locations at the design and ...
Representing mechanical assemblies with features and mating conditions
(Texas A&M University, 1993)
A high-level product representation has been developed and implemented, using design features for part description and mating conditions between features for the relationships among parts. The underlying ideas are that ...
An experimental study concerning the effect of temperature on phase velocity in a 3 layered, steel-Polydimethylsiloxane-steel, plate
(Texas A&M University, 1993)
The intent of this research is to determine if changes in the macromechanical material properties of Polydimethylsfloxane (PDMS) produce appreciable changes in the phase or group velocity of waves in a 3 layered plate. ...
Synchronized droplet size measurements of intermittent coal-water slurry diesel sprays from an electronically-controlled accumulator fuel injection system
(Texas A&M University, 1993)
Experiments have been completed to characterize atomization of intermittent coal-water slurry sprays from an electronically controlled accumulator fuel injection system of a diesel fuel engine. A synchronized laser ...