Search
Now showing items 451-460 of 490
Microfracture fabric of the Punchbowl fault zone, San Andreas System, California
(Texas A&M University, 1999)
The origin of fault zone structure is not completely understood. On the basis of mechanistic models of faulting, the characteristic internal structure of faults may largely be established early during growth of the fault, ...
An economical optical system design using phase diversity
(Texas A&M University, 1999)
The resolution of an incoherent imaging system is olden limited aberrations. Phase aberrations by phase arise from a variety of sources including atmospheric turbulence, misaligned optical and improper mirror figure. ...
QoS enhancement with partial state
(Texas A&M University, 1999)
Considerable work has been done in devising mechanisms for providing service guarantees within a network. These schemes can be broadly classified into two categories, schemes that require maintaining state for each flow ...
Accurate resistive bridge fault modeling, simulation, and test generation
(Texas A&M University, 1999)
Resistive bridging faults in CMOS combinational circuits are studied in this work. Bridging faults are modeled using HSPICE circuit simulation of the various types of bridging faults that can occur in CMOS combinational ...
A direct AC-to-DC converter topology with high-frequency isolation
(Texas A&M University, 1994)
With the increasing need for source and load isolation for safer operation, higher power density (compact size), and higher power factor requirement in the modem computer power supplies and military applications, the power ...
Synchronization of multimedia streams over packet-switched networks
(Texas A&M University, 1995)
Continuing advances in data compression and network technology have made it possible to transmit real-time multimedia data over packet-switched networks. In the past, compression has been the most dominant issue involved ...
Improving the accuracy of SRAM-based failure analysis using IDDQ testing
(Texas A&M University, 1998)
is a primary means of identifying defects in semiconductor manufacturing processes. Defect monitoring is most often done by conventional voltage tasting, but voltage measurements do not always provide a unique mapping into ...
FIESTA II a software tool for electronic filter design
(Texas A&M University, 1997)
This thesis describes a software program, FIESTA II, for the design of electronic filters. It is an expanded version of the FIESTA program written at Texas A&M University in 1989. It is a complete tool for both approximation ...
Evaluation of data and request distribution policies in clustered servers
(Texas A&M University, 1999)
The popularity of the WWW has skyrocketed beyond all expectations and as a result the demands placed on traditional single machine servers has exceeded their original designs. Clustered-based servers are considered to be ...
Development of a simulation model for analysis of MPOA and LANE networks
(Texas A&M University, 1999)
In this thesis a simulation model for inter-Emulated LAN (ELAN) communication using Multi-Protocol Over ATM (MPOA) technology is developed. The network traffic generators for the model are discussed on the basis of ...