Search
Now showing items 941-950 of 993
Structural reliability of brittle materials - an analytical method
(Texas A&M University, 1967)
Not available
Vibrations of circular steel plates with damping
(Texas A&M University, 1967)
Not available
Simulation study of two-stroke cycle compression ignition engines
(Texas A&M University, 1985)
Not available
Computation of cavity-by-cavity flow development in generic labyrinth seals
(Texas A&M University, 1986)
Not available
Numerical simulation of geometry effects for concentric-rotor labyrinth seals
(Texas A&M University, 1986)
Not available
Determining the effect of seawater on the interfacial shear strength of fiber reinforced epoxies using the single fiber fragmentation test
(Texas A&M University, 1996)
Potential uses for fiber reinforced polymer composite materials in the petroleum industry, especially in offshore applications, is substantial. Most fiber reinforced polymer composites currently used in offshore are found ...
Evaluation of Mixing Downstream of Tees in Duct Systems with Respect to Single Point Representative Air Sampling
(Texas A&M University, 2003)
Air duct systems in nuclear facilities must meet the requirements of ANSI N13.1-1999 and the Environmental Protection Agency (EPA) that the exhaust airflow be monitored with continuous sampling in case of an accidental ...
Numerical simulation of micro-fluidic passive and active mixers
(Texas A&M University, 2002)
Numerical simulations of mixing using passive and active techniques are performed. For passive mixing, numerical modeling of a micro-fluidic device, build by Holden and Cremer, was performed. The micro-fluidic device ...
Turbulent heat transfer in rotating rectangular cooling channels with angled ribs and dimples
(Texas A&M University, 2001)
An investigation into determining the effect of rotation on heat transfer in smooth, rib-roughened, and dimpled rectangular channels with aspect ratio of 4:1 is detailed in this thesis. Internal cooling channels are ...
Buckling and vibration of orthotropic plates with an internal line hinge
(Texas A&M University, 2001)
This study presents analytical solutions for the buckling and vibration of uniaxially/biaxially loaded orthotropic thin and thick rectangular plates with an internal line hinge. The plate is taken to be flat, rectangular, ...