Abstract
The unique thermal and mechanical properties exhibited by shape memory alloys (SMAs) present exciting design possibilities in the field of aerospace engineering. When properly trained, SMA wires act as linear actuators by contracting when heated and returning to their original shape when cooled. These SMA wire actuators can be attached to points on the inside of an airfoil, and can be activated to alter the shape of the airfoil. This shape-change can effectively increase the efficiency of a wing in flight at several different flow regimes. To determine the necessary placement of the SMA wire actuators within the wing, an optimization method that incorporates a coupled structural, thermal, and aerodynamic analysis has been utilized. Due to the complexity of the analyses in question, a global optimization method must be implemented. A genetic algorithm has been chosen as the optimization tool to efficiently converge to a design solution. The genetic algorithm used in this case is a hybrid version with global search and optimization capabilities augmented by the simplex method with selective line search as a local search technique. The genetic algorithm has been used to optimize this design problem to maximize the lift-to-drag ratio for a reconfigured airfoil shape at subsonic flow conditions. A wind tunnel model reconfigurable wing was fabricated based on the design optimization to verify the predicted structural and aerodynamic response. Wind tunnel tests indicated an increase in lift for a given flow velocity and angle of attack by activating the SMA wire actuators. The pressure data taken during the wind tunnel tests followed the trends expected from the numerical pressure results.
Strelec, Justin Kent (2002). Design and implementation of a shape memory alloy actuated reconfigurable wing. Master's thesis, Texas A&M University. Available electronically from
https : / /hdl .handle .net /1969 .1 /ETD -TAMU -2002 -THESIS -S773.